Oil & Gas Glossary 1.0

To loosen a collar or other threaded connection by striking it with a hammer.

A tapered connection with 8 threads per inch. One turn equals 0.125 inches of travel. Very common oilfield connection.

A connection with the threads on the outside.

The relatively small amount of gas that enters a well when the mud pump is stopped for a connection to be made. Since bottomhole pressure decreases when the pump is stopped, gas may enter the well.

To tighten a threaded connection.

A connection that can be unscrewed by hand.

A special threaded connection

The joining of two length of pipe.

The female section of a connection. See tool joint.

To guide the end of a pipe into a coupling when making up a connection.

A pipe or rod coupling with the threads on the inside.

The curved connection between the rotary hose and the swivel.

connection of treating line during well servicing, from pump trucks to tree/well

A piece of pipe that has been twisted off inside a female connection; or a short section of material, such as belting or pipe, used to lengthen existing equipment.

1. a pipe connection around a valve or other control mechanism that is installed to permit passage of fluid through the line while adjustments or repairs are being made on the control.

2. in power transmission, a connection extending longitudinally between a driving shaft and a driven shaft. Most such couplings are flexible and compensate for minor misalignment of the two shafts.

An accessory attached o the top of the drill pipe or tubing to form a connection with the mud system to permit circulation of the drilling mud. In some cases, it is also a rotating head.

To make up connection one more turn.

A special type of flanged connection in which a metal ring (resting in a groove in he flange) serves as a pressure seal between the two flanges.

A flanged fitting that supports the tubing string, seals off pressure between the casing and the outside of the tubing, and provides a connection that supports the Christmas tree.

To attach a joint of drill pipe onto the drill stem suspended in the wellbore to permit deepening the wellbore by the length of the joint added (about 30 feet, or 9 meters).

A well drilled to (1) obtain a water supply to support drilling or plant operations, or (2) obtain a water supply to be used in connection with an improved recovery program.

A rotary tool that is hung from the rotary hook and traveling block to suspend the drill stem and to permit it to rotate freely. it also provides a connection fore the rotary hose and a passageway of the flow of drilling fluid into the drill stem.

A workover performed with a continuous steel tube, normally 3/4 inch to 1 inch outside diameter, which is run into the well in one piece inside the normal tubing. Lengths of the tubing up to 16,000 feet are stored on the surface on a reel in a manner similar to that used for wireline. The unit is rigged up over the wellhead. The tubing is injected through a control head that seals off the tubing and makes a pressure-tight connection. A unique feature of the unit is that it allows continuous circulation while it is being lowered into the hole.